6. Advanced configuration
Barco – Argus X Terminal – DOC-3265-2 – user's manual – Revision 06 – February-2005
___________________________________________________________________
6-18
6.1.9
BIOS settings for Wake On LAN
In a distributed A
RGUS
system that is delivered with X server release 3.48 or newer, the BIOS of the mainboards
of the rendering processors is already configured to enable Wake On LAN (WOL). If you want to check the set-
tings or if it is necessary to enable WOL for another reason (e.g. if you want to use the onboard LAN adapter and
to remove the rendering network cards with Etherboot mechanism, please refer to section
) you
can do the following provided that you have an A
RGUS
model with order number RSAGS33282 or higher:
•
Switch off the complete A
RGUS
system, please refer to section
, but leave the power switch
[35] of the rendering processor on.
Repeat the following for all rendering processors:
•
Connect a keyboard to the rendering processor
•
Switch on this rendering processor by its power button [13] at the front.
•
The device starts booting. On one channel of the display wall its graphical output is displayed. As soon as the
system offers to enter the BIOS, press the
F2
-key.
•
Within the BIOS take care that the following settings are selected:
Power
Power
On/Off
LAN
:
Enabled
Power Failure Recovery :
Previous State
•
If using the onboard LAN adapter, check that its use is enabled in the BIOS.
Peripheral Configuration
LAN
Controller
Enabled
•
Save the BIOS settings and exit the BIOS.
•
Switch off the device by its power button [13] at the front.
•
Disconnect the keyboard
After configuring all rendering processors, you can switch on the whole system again, please refer to section