Barco AEC R9650105, Installation Manual

Page: 20 / 27

3. Physical Installation
The AEC does not have a power output connector.
Procedure
1. Place a power linking cable between the ’POWER IN’ socket of the AEC and the ’POWER OUT’ socket of the last tile in a power
circuit of maximum six tiles.
2. Place a data linking cable between the ’DATA IN’ socket of the AEC and the ’DATA OUT’ socket of a tile nearby the AEC.
3. Place an other data linking cable between the ’DATA OUT’ socket of the AEC and the ’DATA IN’ socket of the next tile.
4. In case the AEC is the last element in the data stream and because of that the ’DATA OUT’ is not used, place a dummy data
plug in the unused data socket. (image 3-7, image 3-8)
5. Make sure that the unused socket hole of the AEC is sealed with a plastic cap.
6. Make sure that all plug holder clamps are locked firmly.
Image 3-7
Dummy data plug (R9850270)
Image 3-8
Sealing rings
A Red sealing ring for ’DATA
IN’ and ’DATA OUT’ sockets
(B361595).
B Black sealing ring for ’POWER
IN’ and ’POWER OUT’ sockets
(B361243).
Check if the correct sealing rings are present in the connector sockets of the AEC and the connector sockets
of the tiles connected with the AEC. Replace damaged sealing rings immediately. Use the correct sealing ring
for the corresponding socket. Black colored ring for power, red for data.
14 R5976153 AEC 04112002