7
WHAT YOU NEED
STEP 5: Attach The Side Burner (if purchased)
Assembling Your Side Burner
7 x 15mm short screws
Remove the 4 screws on the right side of the
barbeque as shown.
Remove these screws
Screw 6pcs * 15mm short screws into the right
side of the barbeque as shown.
Do not screw in all the way – leave a 5mm gap to
allow you to hang the side burner in the next step.
Attach the side burner to the right side of the
barbeque as shown.
The keyhole shaped holes in the side burner t over
the screws which were used in the previous step.
Push the side burner over the screws and then
press the shelf downwards until the screws lock
into the narrow part of the keyhole. The shelf should
now line up neatly with the barbeque.
Tighten the six screws.
15mm short screws
Use 1pcs 15mm short screw which was
removed from the barbeque in the
previous step, and thread it through the
side shelf and back into the front corner
hole in the barbeque control panel as
shown
Follow the next steps to connect the side burner to the gas supply.
Note: This view shows
underneath the side shelf.
