3-1
8
For LP Model(BGTSB15ALP), install Tank Holder Brackets and LP Regulator
CAUTION: Build your island before installing the LP Gas Tank and Partition Panel (not included in this unit).
Refer to the heights listed in Fig. 4 for constructing your side burner island. An island unit is not included
with the purchase of your Side Burner.
NOTE:The connector should be installed on a rigid structure without any sharp point or sharp edge
and easy to be seen.
Before installing the Tank Tray Set, you will need to make 3 holes on your Island Bottom Panel .
You will also need to make a hole in your Island Bottom Panel to accommodate your LP Gas Tank.
Make sure the diameter of the hole is at least 9 inches. Make sure the depth of the hole is greater
than the height of the gas tank seat.
Install the Bracket with Regulator onto the Island Side Panel using 2 Pan Head Screws 3/16"x3/8".
Install the Stainless Steel Tube (not included in this unit) onto the manifold. Next, insert the other end
of the Stainless Steel Tube through the hole on the Island's Side Panel. Install the Stainless Steel Tube
onto the male fitting on the Bracket.
Install the Tank Tray Set onto the Island Bottom Panel using 3 Pan Head Screws 3/16"x3/8" as
shown in Fig. 3.
Place the LP Gas Tank into the Tank Tray Set so that the tank valve faces the right rear corner.
Install LP Regulator onto the Gas Tank.
Fig. 3
Island Bottom
Panel
Tank Tray Set
Pan Head Screw
3/16"x3/8"
Qty. 5
Part # S182G03061
Fig. 4
3-2
For LP Model(BGTSB15ALP), install Partition Panel
Partition Panel
(above the Gas Tank)
5"
22-24"
21"
1"
17-19"
5"
Vent Openings must
be at least 1/8" wide.
CAUTION:
There shall be a minimum clearance of 2 inches (50.8 mm) between the floor of the
LP-gas cylinder enclosure and the ground.
CSA Approved Stainless Steel braided hose
(Not provided) must comply with the Standard
for Connectors for Outdoor Gas Appliances and
Manufactured Homes, ANSI Z21.75/CSA 6.27,
and suitable for outside installation. The maxi-
mu m le ng th o f th e co nn ec tion s ha ll b e 6
ft(1.82m).
The gas grill is designed for use with a maximum of 20 lb tank. As per standard, a partition
panel (not included) or equivalent device is required to be installed in the left cabinet of the island
for preventing the use of 30 lb tank. (See Fig.4)
Note:
Make sure there is 22~24" of clearance between the partition panel and tank tray set. The
space around the gas tank is not greater than 12".
