48
UNILUX-3 200 L / 200 R / 300
Do I have to take any extra measures if the room I am heating has an
extractor fan (mechanical ventilation)?
A fl ue gas fan is required for permanent extraction of the area in which the
fi replace is placed.
The type of fl ue gas fan depends on the capacity of the extractor system.
Always consult your installation engineer about this.
What is creosote?
Creosote is a tar-like deposit which is left in the chimney. It is formed in poor
combustion conditions when burning wood (damp wood, pinching off the
air supply to the fi re or burning impregnated or painted wood for example).
Creosote ignites at approx. 500°C. This temperature can easily be reached if the
fi re is raging. This means that deposits of creosote in your chimney could cause
a chimney fi re.
What happens when wood is burnt?
The combustion process.
The combustion of wood involves the following steps.
Drying
The fi rst step is that the fuel (wood) dries out. Even at low temperatures
(~ 100°C), any moisture still in the wood will evaporate. This drying procedure
implies a signifi cant loss of energy if wood which is ‘too’ damp is burnt. The
right degree of moisture is achieved after 1.5 - 2 years of drying. The moisture
content is then 15 - 17%.
Decomposition
At moderate - high temperatures (150°C - 350°C), the decomposition process
can be discerned. This is when the chemical structure of the fuel breaks down.
This process involves the creation of volatile compounds such as carbon
monoxide (CO), water vapour (H
2
O) and methane (CH
4
). In addition, substances
which are volatile at decomposition temperature but condense at lower
temperatures are often released. These are the tar-like components (this by-
product is also known as creosote, which is deposited in the chimney and cold
parts of the fi re in poor burning conditions).
Combustion of the products of decomposition
The volatile compounds burn in the gas phase if O
2
(air) is added. The ignition
temperature of these volatile compounds is approx. 550°C.
Combustion of solid hydrocarbons
The solid component that remains consists of pure hydrocarbons, which will burn
at approx. 800°C if O
2
(air) is added.
Summary of Contents for UNILUX-3200 L
