11
INSTRUCTIONS FOR THE INSTALLER
Installation must be performed by a qualified installer and conform to local codes,
and carried out with extreme care.
Prior to installation, ensure that the local distribution conditions (nature of gas and
gas pressure) and the adjustments of the appliance are compatible.
The gas adjustment conditions for this appliance are stated on the data plate
located on the back of the appliance (see fig. 6).
Fig. 6
- Connection to the mains.
Check the following before connecting to the mains:
-The domestic network must be suitable for the load of the appliance; this
information is on the data plate on the rear of the oven Fig.6, on the guarantee
and the notes on “Technical characteristics”.
-The power supply must have an efficient earthing connection according to the
norms and local standards. In different case the earthing connection must be
make;
-The connection switch or socket must be within reach of the appliance installed;
The power supply cable, supplied with the appliance, should be provided with a
standardized plug that can take the load indicated on the data plate; the plug
should then be inserted in a suitable socket. If you want to connect the cable
directly to the distribution network, there must be an omnipolar switch with a
minimum opening of 3 mm between contacts.
This must be located between the appliance and the power network, in
accordance with the applicable safety standards; the green yellow earthing cable
must not be interrupted. In any case make sure that the power supply cable never
reaches, in any point, a temperature above 50°C.
Summary of Contents for B120 M Series
Page 25: ...25 ...
