BC/BL/BLR2604 Programming Guide
6
Data editing
Start of Configuration
6.1
Prefix and suffix
This option allows you to append a prefix and/or a suffix
to every message transmitted. There is no restriction in
selecting prefix or suffix characters as far as the sum of
the lengths of prefix and suffix is not greater than 10
digits.
You must enable prefix/suffix with the
BaracodaManager previously to configurate prefix
and/or suffix (see 2604 protocol or
BaracodaManager document)
Prefix
Suffix
Set
1.
Select either prefix or suffix
you are going to program by
scanning the corresponding
label
2.
Scan the character(s) you
want from the enclosed
ASCII table to set as prefix or
suffix (be sure to enable full
ASCII code 39 option before
you start).
3.
Read the “Set” label to set
your choice into memory
.
6.2
Barcode identifier code selection
The scanners can transmit max.2-digit barcode identifier
code for different types of barcodes. Use the labels to
choose transmit or not transmit predefined barcode
identifier code (ID’s are listed on section 1):
Enable
Disable
6.3
Barcode identifier code setting
Each of the series type scanners can set max.2 digits as
barcode identifier code according to different barcode.
The procedure is as follows:
1.
Scan “Start of configuration” label
2.
Scan “Barcode identifier setting code” label.
3.
Scan the new code mark from ASCII table (max. two
digits). For example, if one “AB” want for code mark
then scan “A” and “B”.
4.
Scan “Set” label.
5.
Scan “ End of configuration” label.
UPC-E
UPC-A
EAN-13
EAN-8
Chinese post code
ITF 2 OF 5
Coda bar
Code 39
Code 128
© Baracoda 2004
Page 17/22