INSTALLATION AND USE
Connect the lance to the
H.P. hose.
Connect the other extremity
of the H.P. hose to the water
outlet coupling.
ELECTRICAL FEEDING
Connect the water supply
hose to the water inlet
coupling.
Connect the other extremity of the
supply hose to the water tap. Make
sure that the quantity of water
which feeds to the hydrocleaner is
equal to the pump capacity.
Make sure that the net tension is equal to the one printed on the identification data plate on the hydrocleaner. The current tap must be in compliance
with the regulations in force in the Country which will use the machine, and it must have the heart discharge. The current tap must be protected
with a differential magnetic-thermal switch with a sensitivity below 30 mA (safety-system). Don’t connect the same current tap to other plugs. Before
plugging in, make sure that the switch is in “OFF” position.
EXTERNAL TANK DETERGENT SUCTION
Turn the regulable head clockwise as
indicated by the arrow to obtain the
retour at max. press.
Handle
Water gun
Lance
Regulable head
Water nozzle
WARNING
:
Respect the laws of the country when the hydrocleaner is used relatively to the use and digesting of the products employed
to clean. Use only products recommended by the constructor.
Open the water
feeding tap.
STARTING
ON
OFF
GENERAL
Thermostat
Set the start switch
to ON keeping the
thermostat to a
minimum.
Open the water gun pressing
the gun trigger and keep it in
this position for some seconds
in order to eliminate the air in
the hoses.
At the end of the work,
cut-of the hydrocleaner turning
the switch in the“OFF” position
than, open the water gun to
discharge the residual pressure
in the H.P. hose.
Put the detergent
suction hose with
filter into the tank.
Turn the regulable head
counter clockwise as indicated
by the arrow in order to get
the detergent suction and
dispensing in low pressure.
TST
With TOTAL STOP system, the pressure washer shuts off automatically when you close the water gun by means a timer. The relighting of the
pressure washer is automatically pressing the water gun trigger.
DBM
The machine is equipped with a dispositive (Minimum Coil Device) that control the voltage. In case of power outage, the machine goes into block
avoiding dangerous or unwanted restarting. How to intervene: after you have restoredd the normal conditions, bring the selector in “0” position than
restart.
DLG
The machine automatically checks the eventual gasoil lack (Gasoil Level Device): Lamp ignition (flashing) of the red LED placed on the control
panel by means of the temporary closure of the diesel solenoid valve in order to avoid unnecessary shots of smoke. After 15 seconds, automatically
cut-off the burner motor and the starting transformer blocking the fuel pump in order to avoid dangerous seizures. How to intervene: after you have
restored the normal conditions, bring the selector in “0” position than restart.
For cold water functioning only, put the general switch in position.1. For hot water functioning put the switch in position 2 than, adjust the water
temperature by means the thermostat.
To turn off, repeat the operations at the contrary having the foresight to leave operate the machine with cold water for at least two minutes in order
to cool the coil.
WARNING
When using the hydrocleaner, the operator must wear suitable clothes in order to protect himself. Use protection glasses,
anti skid rubber shoes, gloves and overalls.
FUNZIONAMENTO DISPOSITIVI DI SICUREZZA
