Bar Maid Model JUC-200 High Output Commercial Citrus Juicer
|
3
WARNING: The use of attachments not approved by Bar Maid may cause injuries.
WARNING: This product can expose you to Bisphenol A, which is known to the State of California to cause birth
defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
WARNING: Service should be performed at an authorized Bar Maid Service Center.
CAUTION: Use machine only for the purpose it was intended.
CAUTION: Use only genuine Bar Maid
®
replacement parts.
ASSEMBLY
Before using your juicer for the first time, remove any packaging material and promotional labels. Ensure the appliance
is switched off at the power outlet and the power cord is unplugged. Wash the removable parts (stainless steel bowl,
stainless steel pulp filter, splashguard and juicing cones) in warm, soapy water with a soft cloth. Rinse and dry thoroughly.
Do not place parts in the dishwasher.
ASSEMBLInG THE JUICER
1.
Place the motor base on a flat, dry surface. Ensure that the motor base is switched off and the power cord is unplugged.
2.
Place the stainless steel bowl, stainless steel pulp filter, splashguard and juicing cone on top of the motor base.
3.
Plug the power cord into a power outlet.
dISASSEMBLInG THE JUICER
1.
Always ensure your juicer is switched off. Then unplug the power cord.
2.
Remove the the stainless steel bowl, stainless steel pulp filter, splashguard and juicing cone from the motor base by
grasping and lifting upward. Separate the parts for easy cleaning.
OPERATING INSTRUCTIONS
NOTE:
When using your juicer for the first time, you may notice an odor coming from the motor. This is normal and will
dissipate with use.
1.
Ensure the juicer is cleaned thoroughly and correctly assembled with a container placed
under the juice spout before juicing.
2.
Cut citrus fruit in half by cutting across the diameter, not tip to tip, to ensure more
efficient juicing. For the best contact with the fruit cone, smooth the outside of the fruit
by trimming any tip ends such as the ends of a lemon or tangelo.
3.
Plug the power cord into a properly grounded power outlet and then switch the ON/OFF
button to ON. This begins operation of the juicer. The motor will start and juicing cones will rotate.
4.
Place citrus fruit half with the cut side down onto the juice cone. Be careful not to press too hard. Use caution not to
contact moving parts with your hands.
5.
The juice will be extracted from the fruit and flow through the juice spout into the container. The pulp and seeds will
collect in the stainless steel filter.
6.
The Bar Maid High Output Commercial Citrus Juicer juices very quickly so fruit halves will be juiced in a few seconds.
To stop the motor, turn switch to OFF.
7.
Remove the used fruit from the juicing cone. Empty excess pulp and seeds from stainless steel filter as required.
Repeat steps 4-7 to continue juicing.
NOTE:
The stainless steel filter should be emptied when full with pulp and seeds. The filter can be emptied during juicing
by switching the juicer OFF and carefully removing the juicing cone and filter. Clean and replace stainless steel filter and
juicing cone before continuing to juice. Do not allow the stainless steel filter to overfill as this may prevent correct operation
or damage the unit.
