
Place the rear wind shield against the back of the
fire tray facing inwards and locate loosely in posi-
tion via an M6 x 10mm screw , washer-nut in the
lower central fixing hole.
See drawing 10
Stage Three - Assemble the lid
Stage Four - Assemble the wind shield
Attach the top cover to the oven with top cover
hinges and 6 of M5 x 10 screws and washer-nuts
using M5 spanner.
See drawing 8
Open the top cover , attach the right and left lid
stays to the top cover by crossing them through
the hole on the right and left side of the top cover
and then put the end into the square holes in the
oven.
See drawing 8-1.
Locate the two cover handle brackets onto the
outside of the top cover over the two 6mm
clearance holes. Use the two of M6 x 10mm Screws
washer-nuts and secure onto the top cover .
Locate the handle between the brackets and
pass the top cover handle stud through the
holes in the bracket and handle. Tighten all nuts
and fasten handle using 2 x domed nuts and M6
washers.
See drawing 9.
6
O
O
S
A
A
O
O
N
P
G
gg
dd
mm
dd
mm
dd
bb
kk
ii