Important
Please read the following instructions carfully and completely BEFORE attempting to assemble the
barbecue. Keep all polythene wrappers away from children and dispose of all wrapping cartons thoughtfully.
Great care is taken during the manufacture of your barbecue to eliminate sharp edges. However, please
take care when assembling the barbecue to avoid injury
TOOLS NEEDED: CROSS HEAD SCREWDRIVER, SET OF METRIC SPANNERS OR ADJUSTABLE SPANNER AND A
CLEAN NON ABRASIVE SURFACE LARGE ENOUGH TO LAY THE FIRE TRAY UPSIDE DOWN
1. Check that you have all the parts and fixings listed above
2. Check parts for damage
3. Carefully clear any holes covered with paint or enamel.
4. For easier assembly, fit all screws and nuts initially hand tightened only
Stage One - Assemble the oven door
Assembly Instructions
Assemble the oven door. Place the oven on its base . With
the door fully open insert the door stay linkage into the
slotted bracket located on the left hand side and the inside of
the door opening. Bend over both protruding lock tabs to
secure the door stay linkage .
Fit the other end of the door stay linkage to the oven
door-mounting bracket. Note that the washer fits between
the door stay linkage and the door-mounting bracket.
Tighten the nut only so far as to make the door movement
slightly stiff and that the door remains in the position that it is
left in without dropping.
See drawing 1.
Pass the oven door handle through the hole in the oven
door lip and screw two M5 nuts to the top of the thread on
the handle and fit two M5 washers to the exposed
thread, pass the exposed threads through the oven door panel
and fit one M5 nut to each thread and turn onto the thread
until the nut is flush with the exposed thread. Fully tighten the
handle by turning the nut in between the lip and the door.
See drawing 2
4
U
H
H
aa
aa
aa
aa
ii
ii
ii
