Installation and Operating Instructions
________________________________________________________________________________________________________________________________________________________________
17614_ins_wireless_900_rcvr
Specifications subject to change without notice.
___________________________________________________________________________________________________________________________________________________________________________________
Building Automation Products Inc., 750 North Royal Avenue, Gays Mills WI 54631 USA
Tel. +1-608-735-4800
Fax +1-608-735-4804
E-mail:[email protected]
Web:www.bapihvac.com
Page 3 of 4
Rev 05/07/2007
Mount Receiver
Mount 1st Analog Output Module
Mount 2nd Analog Output Module
Mount a BA/RCV900 to a surface with four screws as shown in Figure 6. Slide an analog output module onto the receiver
until it's connectors are fully mated into the receiver. Attach the analog output module to the surface with two screws as
shown in figure 7. Slide additional analog output modules on the end as shown in Figure 8. Make sure to attach each
additional analog output module to the surface with two screws. The next module coves the previous one's screws, so
remember to drive the screws as you proceed.
You may attach up to 127 analog output modules by mating each new one into the analog output module on the end of
the train. If you wish to connect more output modules than can fit on your surface, place additional analog output modules
nearby and connect wires from the right end of the train to the additional analog output module. Continue to place
additional analog output modules to the right of the first additional analog output module and sliding them into place.
Remember to screw the analog output modules in place as you go.
RS485 Analog Output Module Network
Shielded, Twisted Pair Cable
VC75 Voltage
Converter
24VAC 12 VA
Transformer
