Installation and Operating Instructions
________________________________________________________________________________________________________________________________________________________________
17614_ins_wireless_900_rcvr
Specifications subject to change without notice.
___________________________________________________________________________________________________________________________________________________________________________________
Building Automation Products Inc., 750 North Royal Avenue, Gays Mills WI 54631 USA
Tel. +1-608-735-4800
Fax +1-608-735-4804
E-mail:[email protected]
Web:www.bapihvac.com
Page 2 of 4
Rev 05/07/2007
There are several ways to mount the receiver. Connect a DC voltage of 9 to 15VDC to the receiver. Make sure that the
Power Bus negative (-) is connected to the controller's analog ground.
Insert the BA/RCV900 into a piece of snaptrack. Insert into the snaptrack just to the right of the receiver an analog output
module, slide the module to the left until it's connectors are fully mated into the receiver. You may attach up to 127 analog
output modules by mating each new one into the analog output module on the end of the train. If you wish to connect
more output modules than room in your snap track, place another piece of snap track nearby and connect wires from the
right end of the train to an analog output module on the left end of the second piece of snaptrack. Continue to place
additional analog output modules in the second piece of snaptrack to the right of the first additional analog output module
and sliding them into place.
DIN Rail mount
Clip a BA/RCV900 onto a piece of DIN Rail. Clip onto the DIN Rail just to the right of the receiver an analog output
module, slide the module to the left until it's connectors are fully mated into the receiver. You may attach up to 127 analog
output modules by mating each new one into the analog output module on the end of the train. If you wish to connect
more output modules than room on your DIN Rail, place another piece of DIN Rail nearby and connect wires from the
right end of the train to an analog output module on the left end of the second piece of DIN Rail. Continue to place
additional analog output modules on the second piece of DIN Rail to the right of the first additional analog output module
and sliding them into place.
Snaptrack Mount
DIN Rail Clip
