ADVANCED OPERATION
22. FREQUENCY SHIFT "OFFSE"
The "OFFSET" is the difference or offset between the reception frequency and the
frequency of transmission for access to amateur radio repeaters. Set the "OFFSET"
according to the "OFFSET" amateur radio repeater through which want
to communicate.
Follow these steps to set the "OFFSET" Frequency:
1. Press the [MENU], then press [UP]/[DOWN] to select the Menu 22 "OFFSET".
2. Press [AB/
], then directly enter digits (VHF: 0-37.995MHz, UHF: 0-69.995MHz).
3. Press [AB/
] to save the setting.
4. Press [MENU] or any numeric key to exit.
23. SCAN TYPE "SCANM"
This transceiver allows you to scan memory channels, all the bands or part of the
bands. When the transceiver detects a communication, the scan will stop
automatically.
Set the desired scanning type, using the following procedure:
1. Press the [MENU], then press [UP]/[DOWN] to select the Menu 23 "SCANM".
2. Press [AB/
], then press [UP]/[DOWN] to select SE/TO/CO.
3. Press [AB/
] to save the setting.
4. Press [MENU] or any numeric key to exit.
Note:
- "TO" (Time Operation): Scanning will stop when it detects an active signal. The
scanning will stop on each channel or active frequency for a predetermined time,
after that time the scan wil resume automatically.
- "CO" (Carrier Operation): The scanning will stop and remain in the frequency or
channel, until the active signal disappears.
- "SE"(Search Operation): The scanning will stop and remain in the frequency or
channel after it detects an active signal.
