POL-200 Semiautomatic Polarimeter
1
Introduction
Thank you for selecting the POL-200 semiautomatic polarimeter. This user manual provides a step-by-step guide to help you operate the instrument, please
carefully read the following instructions before use.
UNPACKING THE INSTRUMENT:
Before unpacking, ensure that the current work environment meet following conditions.
●
Ambient temperature is greater than 0
o
C and less than 50
o
C.
●
No potential electromagnetic and ambient light interference.
The following list describes the standard accessories of the polarimeter. After the unpacking, please check all accessories are complete. If any are damaged
or missing, please contact nearest distributor.
●
Test tube 100 and 200 mm
●
Sealing rings
●
Power cable
Power On/Off
●
Plug in the power supply and press ON/OFF key to turn on the polarimeter, the display shows “Wait for light source to stabilize”. After a few seconds,
the default measurement interface shows on the screen.
●
Press ON/OFF key again, the instrument will automatically turn off.
WARNING:
DO NOT pull out the power plug from the power source if the instrument does not completely turned off, that may cause the zero-point offset.
Display
POL-200 semiautomatic polarimeter is equipped with the 5.6 inch touch screen that used to show measured values, function keys and help message. In the
measurement and setting modes, the instrument will show different user interfaces.
………
…..Function Keys
………
….. Measurement Keys
