Specifications
Radio
General
Radio Range
900 MHz: Up to 9.6 kilometers (6 miles) *
2.4 GHz: Up to 3.2 kilometers (2 miles) *
Radio Transmit Power
900 MHz: 30 dBm conducted (up to 36 dBm EIRP)
2.4 GHz: 18 dBm conducted, less than or equal to 20
dBm EIRP
900 MHz Compliance (1 Watt Radios)
FCC ID UE3RM1809: This device complies with FCC
Part 15, Subpart C, 15.247
IC: 7044A-RM1809
2.4 GHz Compliance
FCC ID UE300DX80-2400 - This device complies with
FCC Part 15, Subpart C, 15.247
ETSI/EN: In accordance with EN 300 328: V1.7.1
(2006-05)
IC: 7044A-DX8024
Spread Spectrum Technology
FHSS (Frequency Hopping Spread Spectrum)
* With the 2 dB antenna that ships with the product. High-gain an-
tennas are available, but the range depends on the environment
and line of sight. To determine the range of your wireless network,
perform a Site Survey.
Power*
Requirements: +10 to 30V dc (For European applica-
tions: +10 to 24V dc, ± 10%) on the brown wire, or 3.6
to 5.5V on the gray wire
900 MHz Consumption: Gray wire (3.8V) at 650 mW;
Brown wire (12V) at 900 mW
2.4 GHz Consumption: Gray wire (3.8V) at 120 mW;
Brown wire (12V) at 250 mW
Housing
Polycarbonate housing and rotary dial cover; polyester
labels; EDPM rubber cover gasket; nitrile rubber, non-
sulphur cured button covers
Weight: 0.26 kg (0.57 lbs)
Mounting: #10 or M5 (SS M5 hardware included)
Max. Tightening Torque: 0.56 N·m (5 lbf·in)
Antenna Connection
Ext. Reverse Polarity SMA, 50 Ohms
Max Tightening Torque: 0.45 N·m (4 lbf·in)
Interface
Indicators: Two bi-color LEDs
Buttons: Two
Display: Six character LCD
Wiring Access
One 5-pin Euro-style male connector
* For European applications, power the DX80 from a Limited Pow-
er Source as defined in EN 60950-1.
Notice: This equipment must be professionally installed. The output power must be limited, through the use of firmware or a hardware
attenuator, when using high-gain antennas such that the +36 dBm EIRP limit is not exceeded.
Communication
Environmental
Hardware (MultiHop RS-485)
Interface: 2-wire half-duplex RS-485
Baud rates: 9.6k, 19.2k (default), or 38.4k via DIP
switches; 1200 and 2400 via the MultiHop Configura-
tion Tool
Data format: 8 data bits, no parity, 1 stop bit
Packet Size (MultiHop)
900 MHz: 175 bytes (85 Modbus registers)
2.4 GHz: 125 bytes (60 Modbus registers)
Intercharacter Timing (MultiHop)
3.5 milliseconds
Rating
IEC IP67; NEMA 6; (See UL section below for any ap-
plicable UL specifications)
Operating Conditions
Operating Temperature: −40 to +85° C (Electronics);
−20 to +80° C (LCD)
Operating Humidity: 95% max. relative (non-condens-
ing)
Radiated Immunity: 10 V/m, 80-2700 MHz
(EN61000-6-2)
Shock and Vibration
IEC 68-2-6 and IEC 68-2-7
Shock: 30g, 11 millisecond half sine wave, 18 shocks
Vibration: 0.5 mm p-p, 10 to 60 Hz
Refer to the SureCross
®
MultiHop product manual, Banner p/n
151317, for installation and waterproofing instructions. Operating
the devices at the maximum operating conditions for extended pe-
riods can shorten the life of the device.
SureCross MultiHop Data Radio
P/N 148345 Rev. B
www.bannerengineering.com - tel: 763-544-3164
7
