R-GAGE™ QT50R Series Sensors
P/N 124617 rev. C
5
Banner Engineering Corp
. • Minneapolis, MN U.S.A.
www.bannerengineering.com • Tel: 763.544.3164
Specifications
Specifications are subject to change without notice.
Range
Sensor will detect a 1 m x 1 m metal plate at a distance of up to 7.2 m (24') when set up with a suitable
background target.
Detectable Objects
Objects containing metal or other high-dielectric material
Operating Principle
Frequency-modulated continuous-wave (FMCW) radar
Operating Frequency
24.05 to 24.25 GHz, ISM Band (varies slightly with national telecom regulations)
Supply Voltage
15 to 30V dc
Supply Protection Circuitry
Protected against reverse polarity and transient overvoltages
Delay at Power-up
Less than 1.5 seconds
Output Configuration
Bipolar NPN and PNP outputs, 150 mA (derate 1 mA per °C above 25° C)
Output Protection
Protected against short circuit conditions
Indicators
Power LED:
Green
Signal Strength LED:
Red
Output LEDs:
Yellow/Red
See “Status Indicators” above.
Adjustments
TEACH programming button for setting background reference
Operating Temperature
-20° to 55° C (-4° to 131° F)
Environmental Rating
IEC IP67; NEMA 6
Connections
2 m (6.5') or 9 m (30') 5-conductor, shielded, PVC-jacketed attached cable or integral 5-pin Euro-style QD
Certifications
and ETSI/EN 300 440 or FCC Part 15, depending on model
Status Indicators
Power LED
Indicates
OFF
Power is OFF.
ON Green
Power is ON.
Signal LED
Indicates
TEACH Mode
(signal strength
indicator for
background)
OFF
Background target is not sufficient; use a different
target.
ON Red (flashing)
Frequency of flash indicates alignment. LED flashes
faster as alignment improves; solid ON indicates
best alignment.
RUN Mode
(alignment
indicator for
background
target taught)
OFF
Background target is not being sensed.
ON Red (flashing)
Frequency of flash is proportional to background
target taught; solid ON indicates best alignment.
Output LEDs
Indicate
ON Red
In TEACH mode.
ON Yellow
In RUN mode; target is sensed and outputs are conducting.
CAUTION . . .
Make No Modifications
to this Sensor
Any modifications to this sensor not
expressly approved by Banner Engineering
could void the user’s authority to operate
the sensor.
Contact the Factory for more
information.
