Banner Q5Z, Instruction Manual

Page: 17 / 41

June 23, 2023
Q5Z Global Laser Measurement Sensor With IO-Link Instruction Manual
17
Chapter Contents
5.1 Light Operate/Dark Operate ........................................................................................................................................................................ 17
5.2 Complementary Output ............................................................................................................................................................................... 17
5.3 Set ............................................................................................................................................................................................................... 17
5.4 Laser On/Laser Off ...................................................................................................................................................................................... 17
5.5 Sync Master/Slave ...................................................................................................................................................................................... 17
5.6 Pulse Frequency Modulation (PFM) Output ................................................................................................................................................ 18
The output of Channel 2 can be pre-configured to light operate or dark operate and is independent of Channel 1. The teach
method of both channels is the same.
See "TEACH Procedures" on page 19 for instructions on teaching Channel 2.
In light operate, the output turns on when a target is present inside the switch points of the sensor.
In dark operate, the output turns off when a target is present inside the switch points of the sensor.
Output 2 switches opposite of Output 1.
Allows the Q5Z Global to use its remote input.
For more details, see "Remote Input" on page 15 .
The laser can be controlled to either turn on or off depending on the setting by activating the remote input wire.
For more details, see "Remote Input" on page 15 .
A maximum of two Q5Z Global sensors may be used together in a single sensing application.
To eliminate crosstalk between the two sensors, configure one sensor to be the master and one to be the slave, then connect
the white wires together. In this mode, the sensors alternate taking measurements and the response speed doubles.
NOTE: The master sensor and the slave sensor must be configured for the same Response Speed and
Gain and Sensitivity settings. The master sensor and slave sensor must share a common power source.
Channel 2 Output or Function
Chapter 5
Light Operate/Dark Operate
5.1
Complementary Output
5.2
Set
5.3
Laser On/Laser Off
5.4
Sync Master/Slave
5.5
© Banner Engineering Corp.