5 Specifications
Supply Voltage and Power
16 V DC to 30 V DC; maximum power 12 watts
Supply Protection Circuitry
Protected against reverse polarity and transient voltages
Discrete Output Configuration
Two discrete outputs: Output 1 and Output 2
Outputs can be configured as either NPN or PNP (default setting)
Discrete Output (either NPN or PNP) Ratings
Rated at 30 V DC max, 150 mA max load, short circuit protected
OFF-State Leakage Current: < 10 μA at 30 V DC
ON-State Saturation Voltage: < 1 V DC at 10 mA, < 1.5 V DC at 150 mA
Serial Data Outputs
EIA-485 interface
Auto stream default: FBB, TBB
Baud rate 38400 (Adjustable)
8 data bits, 1 start bit, 1 stop bit, no parity
Sensor Scan Time
Worst-case response time is twice the scan time; see
on p. 3
Cable Connections
Emitter and receiver with Integral 8-pin M12 male quick disconnect
Status Indicators
Easy-to-Understand Diagnostic LEDs
on p. 5
Environmental Rating
IP54
Construction
Aluminum housing with black anodized finish; acrylic lens cover
Operating Conditions
–40 °C to +70 °C (–40 °F to +158 °F)
95% maximum relative humidity (non-condensing)
Controller Programming
Via EIA-485 to Banner Sensors GUI software
Emitter/Receiver Range
2 m (6.5 ft)
Minimum Object Sensitivity
Straight Scan Mode: 38.1 mm (1.5 in)
Interlaced Mode: 25.4 mm (1 in)
Application Notes
The emitter and receiver sync lines (pink and white wires) will be
damaged if connected to the power supply
The receiver EIA-485 interface (red and green wires) will be damaged if
connected to the power supply
Certifications
5.1 Emitter and Receiver Mounting Dimensions
L2
Y
L1 L3
73.1 mm
(2.88”)
(2) M6 x 1 T-nuts for Mounting
Cut out design for T-nut
Emitter/Receiver Models
Array Length (Y)
Housing Length (T-Nut
active) (L1)
Total Length
L2
L3
MBE616Q Emitter
MBR616PX485SQ Receiver
143 mm (5.62 in)
204 mm (8.0 in)
228 mm (9.0 in)
251 mm (9.9 in)
MBE1216Q Emitter
MBR1216PX485SQ Receiver
295 mm (11.62 in)
356 mm (14.0 in)
380 mm (15.0 in)
403 mm (15.9 in)
MINI-ARRAY
®
BASIC Two-Piece Measuring Light Curtain
12
www.bannerengineering.com - Tel: + 1 888 373 6767