Figure 3. M-GAGE receiver window
1. Point the optical commissioning device at the receiver.
The red arrow is pointing to the receiver window.
2. Click and hold the optical commissioning device's button until the red/green LED in the center of the M-GAGE lights up,
about five seconds.
When the device wakes up, the LEDs flash according to the LED table.
To return the M-GAGE back to its deep sleep mode, click and hold the optical commissioning button until the red LED in the center
of the M-GAGE stops blinking, about five seconds.
Bind the M-GAGE to the DXM Controller
Bind the M-GAGE Node to the DXM Controller before burying the M-GAGE.
To bind the M-GAGE Node to the DXM Controller, we have DXM Controller, M-GAGE, and the optical commissioning device (
BWA-
MGFOB-001
) available.
1. Set the DXM Controller's ISM radio to operate at 250 mW.
Before the M-GAGE Node can bind to the DXM Controller, the DXM Controller's ISM radio must be set to operate at 250
mW.
a) On the DXM: Use the up and down arrows to scroll to the
System Config
menu. Press
ENTER
.
b) Scroll to the
ISM Radio
menu and press
ENTER
.
c) Scroll to
RF Power
and press
ENTER
.
d) Scroll to
900 0.25W
and press
ENTER
.
e) Press
ENTER
when the DXM indicates that it needs to restart.
The DXM restarts and returns to the main menu.
2. On the DXM: Scroll down the menu options to
ISM Radio
and press
ENTER
.
3. Select
Binding
and press
ENTER
.
4. Use the arrow buttons to scroll to Node 1 and press
ENTER
.
Each Node within the radio network must have a unique Node ID. This example is referring to Node 1, but the Node ID can
be any valid ID.
The DXM enters binding mode with Node 1.
5. On the M-GAGE Node: Verify the M-GAGE is awake. If it is not awake, see
Wake the M-GAGE from Deep Sleep Mode
page 1.
6. Hold the optical commissioning device to the M-GAGE's receiving window and click the button three times.
Figure 4. Triple-click the button to put the M-GAGE into binding mode
The LED in the center of the M-GAGE Node flashes an alternating red and green. When the both LEDs both are on, the
binding process has started. The final binding process occurs when both LEDs flash in unison four times. After binding is
complete, the M-GAGE Node automatically exits the binding process and reboots.
7. On the DXM: After the M-GAGE Node is bound to the DXM, press the DXM's
BACK
button to exit binding mode.
M-GAGE Installation Instruction Manual
2
www.bannerengineering.com - Tel: + 1 888 373 6767
P/N b_51162884 Rev. A