13
counterclockwise to decrease) until the film passes over the top heat
shoe without wrinkles and the web between the laminating and pull
rollers is tight.
Note: This adjustment should require only a slight turn. If
increased too much, you may stall the drive motor.
Figure 7
5. If necessary, locate the knob on the right side of the bottom supply
mandrel and adjust the tension as in Step 3 above.
Setting Heat Shoe Temperature
The laminator temperature should be adjusted according to the film
thickness and the item being laminated. See recommended temperature
settings from your film supplier. Keep in mind that different brands of
laminating film may require different temperatures.
1. Turn the heater switch on.
2. Use the thermostat adjustment knob (black knob) on the left side of
the laminator to adjust the temperature of the heat shoes.