Banner DX80DR9M-HB1, Manual, Page: 7 / 11

Two Button/LED Models Single Button/LED
Models
Process
Steps
Response LED 1 LED 2 LED
2 The slave/repeater searches for a parent device. Flashes red - Flashes red (1 per 3
sec)
3 A parent device is detected. The slave/repeater searches
for other parent radios within range. Solid red - Solid red
4 The slave/repeater selects a suitable parent. - Solid amber Solid amber
5 The slave/repeater attempts to synchronize to the selec-
ted parent. - Solid red Solid red
6 The slave/repeater is synchronized to the parent. Flashes green - Flashes green
7 The slave/repeater enters RUN mode. Solid green, then
flashes green Solid green, then flash-
es green
Serial data packets begin transmitting between the slave/
repeater and its parent radio. - Flashes amber Flashes amber
Master LED Behavior
All bound radios set to operate as masters follow this LED behavior after powering up.
Two Button/LED Models Single Button/LED
Models
Process
Steps
Response LED 1 LED 2 LED
1 Apply power to the master radio - Solid amber Solid amber
2 The master radio enters RUN mode. Flashes green - Flashes green
Serial data packets begin transmitting between the mas-
ter and its children radios. - Flashes amber Flashes amber
Modbus Register Table
Inputs
Register
(4xxxx)
Input # I/O Type Units I/O Range Holding Register Rep-
resentation Pins
Min. Value Max. Value Min.
(Dec.)
Max.
(Dec.)
1 1
2 2
3 3 Discrete IN 3 - 0 1 0 1 Pin 3
4 4 Discrete IN 4 - 0 1 0 1 Pin 4
5 5 Analog IN 1 mA 0.0 20.0 0 65535 Pin 1
6 6 Analog IN 2 mA 0.0 20.0 0 65535 Pin 2
SureCross MultiHop Data Radio Module
P/N 154365 Rev. C www.bannerengineering.com - tel: 763-544-3164 7