CH 2 Factory Default Settings:
Setting
Factory Default
Out SEL2
LO
tch SEL2
2-pt tch
OFSt Pct2
10 Pct
Auto thr2
oFF
dLY SEL2
oFF
SEnS SEL2
Std
(+)
or
(-)
to set value
(+)
or
(-)
to set value
To scroll through menu lists: Press “+” or “-” To enter a choice list or to select and save: Click SET To exit a choice list without saving: Press and hold SET for 2 seconds
Click SET
to enter choice list
Press and hold SET to exit
choice list without saving
DISPLA
Y
LOOP
Return to Menu List
PROGRAM MODE
Switch Mode
to “PRG”
Click SET
to enter choice list
Click SET
to enter choice list
DISPLA
Y
LOOP
Click SET
to enter choice list
Click SET
rocker button
Click SET to select and save a choice in any list
Menu List
on display represents a “w”
If Master (mASt), indicate number of Slaves (1..6) under subsequent “
totL SLAV
” menu option
If Slave (SL
VE), indicate its address (Master address is 0) under subsequent “
SLAV Addr
” menu option
on display represents a “m”
Click SET
to enter choice list
default setting
setting-specific
Click SET
to enter choice list
D
ISPLA
Y
LOOP
(+)
or
(-)
to set value
Click SET
(+)
or
(-)
to set value
Click SET
(+)
or
(-)
to set value
Click SET
(+)
or
(-)
to set value
Click SET
(+)
or
(-)
to set value
Click SET
DISPLA
Y
LOOP
DISPLA
Y
LOOP
DISPLA
Y
LOOP
Available in Lt, dr or wind set only
Not available in CAL Set
Figure 5. CH 2 Program Mode Chart
3.2.1 Output Selection
Both CH1 and CH2 can be programmed for either light operate (LO) or dark operate (DO). The Channel 2 menu includes
additional options: Health (Health Mode Alarm), Comp (Complementary Programming), Set (sets Channel 2 wire as a remote
input), Mast (selects this unit as the master and then allows you to enter the total number of slaves there will be), Slve
(selects this unit as a slave and then allows you to enter this slave address), LED off, LED on and Gate.
3.2.2 TEACH Selection
The DF-G3 can be programmed for one of the following TEACH/SET methods:
• Two-Point TEACH
• Dynamic TEACH
• Window SET
• Light SET
• Dark SET
• Calibration SET
Note: A TEACH Selection must be selected by programming before TEACH/SET methods can be used.
3.2.3 Response Speed
The DF-G3 can be programmed for one of the following Response Speeds:
DF-G3 Long Range Expert Dual Display Fiber Amplifier with Dual Discrete Outputs and IO Link
www.bannerengineering.com - Tel: + 1 888 373 6767
9