1.Marking the Door
1.1 Mark the edge of your door at the desired
height of your lever. See drill template
below.(Figure 1)
1.2 We recommend around 900mm–1000mm from
floor level, or at the centre of a lock rail
on a panel door.
1.3 Using a spirit level, mark the door at the
desired lever height, continuing the line from
the front of the door, around the edge and
onto the back of the door.(Figure 2)
1.4 We recommend extending the line 100mm
onto each face of the door.
2. Prepare Tie bolts
2.1 If using face fix timber screws
(not recommended) proceed to step 3.2.
2.2 If required, shorten male tie bolt to suit
door thickness.
2.3 Ensure to cut so that the screw has enough
thread (12mm at least) to hold female thread.
(Figure 3)
3. Install Levers
3.1 Drill appropriate size holes and install
the halves on either side of the door,
ensuring the levers function in the correct
direction.(Figure 4)
3.2 Place the split spindles into the latch
from either side of the door.(Figure 5)
3.3 Fit the female tie bolts through
holes of one rose, then fit male tie
bolts through the other side and tighten.
(Figure 5)
IMPORTANT:
Please install this hardware in the following
order to ensure its warranty is not voided.
1. Install the hardware on raw/unfinished
door using the instructions provided.
2. Remove hardware (where possible) and
store safely. Do not place tape onto the
hardware as this will damage the finish.
3. Paint / finish door.
4. Reinstall hardware.
Figure 4
Figure 3
Figure 2
Figure 1
Preferred
product height
(1)
(4)
Figure 5
(4)
(1)
(1)
(4)
(3)
(3)
For number references please refer to included
items on reverse.
