10
96808 v.14 .0
Figure 3:
Six-Gun/EconoMind Diesel Tuner installed on the inner fender
(2003-04 model year vehicles only) (Six-Gun Shown)
5.
Place the Six-Gun/EconoMind Diesel
Tuner in close proximity as shown in
Figure 3
for 2003-04 and
Figure 4
for
2005-07. The ‘In-cab cable’ with the
three small connectors will be routed
into the cabin via the grommet on the
firewall. The MAP sensor harness with
the two connectors will be routed via
the firewall to its prospective location
listed in the following steps.
NoTE: (The Six-Gun/EconoMind Diesel
Tuner will be affixed to its permanent
location in
step 20
.)
6.
Locate the Powertrain control
Module (PcM) on the driver side of
the vehicle engine compartment (see
Figure 5
).
7.
Disconnect the middle connector
from the PcM by opening the
overcenter retaining clamp as shown
in
Figure 5
. Route the disconnected
PCM connector to the Six-Gun/
EconoMind Diesel Tuner as directed
below:
2003-04 model year vehicles: Route
the previously disconnected middle
connector under the power steering
fluid reservoir towards the Six-Gun/
EconoMind Diesel Tuner.
2005-07 model year vehicles: Route
the previously disconnected middle
connector in the most direct path
towards the Six-Gun/EconoMind Diesel
Tuner.
8.
All Years: Plug the PcM connector
into the connector on the Six-Gun/
EconoMind Diesel Tuner labeled,
”VEHIcLE HARNESS”.
9.
Locate the supplied ‘crossover
Cable’ wiring harness in your Six-Gun/
EconoMind tuner kit.
10.
Plug the supplied ‘crossover
Cable’ wiring harness into the Six-Gun/
EconoMind Diesel Tuner connector
labeled, “BANKS HARNESS.”
For 2005-2007 Model vehicles: Slide
Six-Gun/EconoMind Shield onto
crossover cable.
