14
96815 v.1.0
Not needed if optional Banks iQ is
installed.
CAUTION: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
1.
The Six-Gun switch will be installed
on the driver’s side of the instrument
panel (IP) next to the steering column
(see
Figure 10
). carefully remove
the IP from the dashboard by slowly
pulling outwards from the dashboard
around the edges of the IP, allowing
the mounting pins to pull free from
their dashboard sockets. Automatic
transmission equipped vehicles will
need to set the parking brake and
move the shift lever down to the
lowest gear to allow clearance for
instrument panel removal.
2.
cut out the supplied template
(see
Figure 20
on page
27
) and align
the template onto the rear of the IP,
squarely seating it on the top of the IP
mounting pin (see
Figure 11)
.
3.
Using a
3
⁄
8
” Uni-drill bit, center the
bit onto the
3
⁄
8
” drill location on the
template and slowly drill through the
IP. Using a
1
⁄
8
” drill bit, center and
drill through the
1
⁄
8
” location on the
template. Remove and discard the
template and any plastic shavings.
4.
On the front side of the IP, align
the Banks Six-Gun label onto the
previously drilled hole (see
Figure 12
).
5.
Remove the nut and internal tooth
washer from the Six-Gun Switch.
Rotate the shaft counter clockwise
until the shaft stops. Verify the
locating washer tab is inserted into
the #6 position on the switch (see
Figure 13)
.
NOTE: If the washer is in any position
other then the #6, your Six-Gun Diesel
Tuner will not select power levels
properly.
6.
After confirming the locating
washer is in the #6 location, install the
switch through the
3
⁄
8
” hole on the
backside of the instrument panel. The
alignment pin should rest in the
1
⁄
8
”
hole and with the switch fully rotated
counter clockwise; the shaft’s flat side
should be facing the steering column.
Section 3
INSTALLATION OF THE SIx-GUN SELECTOR SWITCH AND
SPEED-LOADER MODULE
Figure 10
