8
NOTE: Before installing the Banks
Super-Scoop make sure to have a
completely installed Banks Ram-Air
Intake System in your vehicle.
1.
Remove all Fasteners or plastic
retainers attached to the fender lining
then remove the wheel liner and set
aside. See
Figure 2
Note: Detach any wire harness clips
from the fender well liner and secure
them out of the way.
2.
Locate supplied brackets and Banks
Super-Scoop. Place the brackets on top
of the Super-Scoop inlet over the slots.
Note the location and direction of the
bracket in
Figure 3
.
Note: For standard bumper vehicles
position the brackets over the larger
slot on the Super-Scoop inlet. See
Figure 3
.
3.
Locate the supplied 20mm push-
in retainers and insert them from the
inside of the Super-Scoop opening
through the slots securing the brackets
to the Super-Scoop. Push in the
retaining pin to expand the retainer
and fasten the Super-Scoop to the
brackets. See
Figure 4
.
4.
From under the vehicle on the
passenger side locate the two (2)
factory nuts attaching the bumper
to the bumper support bracket, see
Figure 5
. Loosen and Remove the
nuts, retain for reuse.
5.
Install the Banks Super-Scoop
from beneath the front bumper and
place the Super-Scoop’s opening over
the bottom of the Banks Ram-Air
housing down spout. If the bottom of
the Banks air housing is sealed, see
pages 8-9 of the Banks Ram-Air Intake
Installation Manual. Insert the brackets
over the frame bolts as shown in
Figure 6
. Re-install the factory nuts
onto the factory bolts. Hand tighten
the nuts at this time.
Section 2
SUPER-SCOOP INSTALLATION
Figure 2
Removal of the passenger side wheel liner.