11
6.
Lift up, align and fit the Banks
Super-Scoop into position as far into
the bottom of the Ram-Air housing
down spout as possible. Using the two
(2) holes on top of the Super-Scoop as
a template, mark the Banks Ram-Air
housing with a marker. See
Figure 7.
7.
Remove the Banks Ram-Air housing
(reference Banks Ram-Air installation
manual for removal). Center punch the
location of the two (2) holes marked
in the previous step then drill using a
step drill to
5⁄16
”.
Note: Make sure the center of the
holes are between
3⁄8
”-
1⁄2
” from
the bottom edge of the housing. See
Figure 8.
8.
Clean the holes and install the
supplied clip-on-nuts over the holes.
Install the clip-on-nut so that the nut is
on the inside of the Ram-Air housing.
See
Figure 8
.
9.
Re-install the Ram-Air housing
following Banks Ram-Air installation
manual. Make sure the Super-Scoop
opening is over the bottom of the
Bank’s Ram-Air housing down spout.
Lift the Super-Scoop into place and
install the supplied
1⁄4
” bolts and
washers through the Super-Scoop
holes attaching to the clip-on-nuts on
the Ram-Air Housing. Hand tighten the
bolts. See
Figure 9
.
10.
Adjust the inlet of the Super-
Scoop to fit the contour of the lower
bumper.
Figure 7
Mark locations of holes on Ram-Air Housing.