Bang & Olufsen BEOSOUND 9000, Setup Manual

Page: 10 / 16

10
BANG & OLUFSEN
1
2
When you switch on via the
red power switch button a tiny
red light appears in the display,
indicating that the system is in
stand-by mode, ready to be
used.
Open the glass door (press the
load-button). Remove the
carton strip behind the CD
clamper and the foam packing
(these items are for transport
protection of the CD drive and
the glass door).
Close-up operation panel
In order to make reading easier
in all placement situations, you
can turn the close-up operation
panel (and thus the display):
– Switch off the power and
open the lid to gain access
to the close-up operation
panel.
– Lift off the operation panel
by inserting a finger where
indicated, turn the panel,
and then insert it (connectors
first) again.
Bang & Olufsen logotype
You can also rotate the CD
clamper lid (with the Bang &
Olufsen logotype) in order to
ensure that the logotype always
appear in a horizontal position.
R E A D Y F O R U S E …
AV setup
If your BeoSound 9000 has been
set up in an AV system, you
may need to program it to the
correct
Option (refer to the
diagrams on the opposite
page):
Option 0. Used in a one-room
fully integrated AV system
with no speakers connected
to the BeoSound 9000.
Option 0 is selected automa-
tically when no speakers (or
headphones) are connected
to the BeoSound 9000.
Option 1 (factory setting). Used
in a one-room setup, when
the BeoSound 9000 is used
either on its own, or in an AV
integrated setup (with a pair
of active speakers connected
to the BeoSound 9000).
Option 2. Used in a two-room
AV integrated setup.
Switch your entire Bang &
Olufsen system to stand-by, and
then (using the Beo4 remote
control):
– Hold the • button while
pressing LIST.
When the Beo4 display reads
OPTION?, press GO.
– Press LIST to display A.OPT
and then key in the appro-
priate number (1 or 2).
Power switch
Load button
Lift here