/QDO@QHMFRDSTO
Preparing setup
Perform the next basic settings before continuing to the setup part.
Connect to mains
Connect the power supply to the mains. When the startup procedure is running (takes approximately one minute), the LED lights red and the
screen is black. The product is ready, when the source menu appears on the screen.
Pincode
6GDMSGDLTRHBRXRSDLHRBNMMDBSDCSNSGDL@HMRENQSGDÖQRSSHLDNQG@RADDMCHRBNMMDBSDCEQNLSGDL@HMRENQLNQDSG@M@OOQNWHL@SDKX
LHMTSDRHSB@MNMKXAD@BSHU@SDCAXRVHSBGHMFHSNM@MCDMSDQHMFSGDOHMBNCD(ESGDOHMBNCDHRMNSDMSDQDCSGDLTRHBRXRSDL@TSNL@SHB@KKX
switches to standby after approximately three minutes. The remote control can not be used for entering the pincode.
> Turn the
wheel
to browse the digits, and press
GO
to select.
> Turn the
wheel
to
STORE
, and press
GO
.
!
If you store a wrong pincode, you get only one more attempt to enter the code, after which the system switches to standby. The system cannot be
switched on again for three hours.
Language
"G@MFDSGDK@MFT@FDSNLDDSSGDBTRSNLDQRODBHÖB@SHNMR
> Use the
pointer
to highlight
MODE
, turn the
wheel
to select
SETTINGS
, and press
GO
.
> Use the
pointer
to highlight
SYSTEM
SETTINGS
, turn the
wheel
to select
LANGUAGE
, and press
GO
.
> Turn the
wheel
to select the language you want, and press
GO
.
!MLjPK.-5#014',%QCRRGLEQ
"NMÖQLSGDRDSSHMFRENQONVDQR@UHMF
> Turn the
wheel
to select
SETTINGS
and press
GO
.
> Use the
pointer
to highlight
SYSTEM SETTINGS
and turn the
wheel
to select
POWER SAVING
and press
GO
.
> Turn the
wheel
to select
YES
or
NO
and press
GO
.
YES
= power saving (default)
NO
= start up faster (increases the standby power consumption).
> Use the
pointer
to leave the menu.
