Bang & Olufsen BeoLink Active, Setting-Up Manual

Page: 7 / 8

7
3501xxx 0963
R E A D Y F O R U S E …
When you have made all the connections as described in
the previous chapter you may start using the system.
However, in order for your setup to function properly, you
may need to preprogram it.
Your BeoLink Active can be preprogrammed for the
following setup situations (Options):
Option 0: To be used if you want to disable remote
control operation of the BeoLink Active (to re-enable
remote control, select one of the other options).
Option 4: To be used if you install the BeoLink Active in
the same room as your central system (e.g. in a large L-
shaped living room with two separate listening positions).
Option 5: To be used if you install a TV set in the same
room as your BeoLink Active.
Option 6: To be used for a setup with the central system
in one room and the BeoLink Active in another, as
described in this guide (this is the factory setting).
NOTE! To ensure correct function
of your setup, it is essential that
you connect both the central
system and the speakers to the
mains – before connecting the
BeoLink Active box to the mains!
Printed in Denmark by
Bogtrykkergården a-s, Struer
Using a Beolink 1000:
– Press LINK, the appropriate
number (0, 4, 5 or 6), and
then STORE.
Using a Beo4:
– Hold the • button while pres-
sing LIST. When the Beo4
display reads OPTION?, press
GO.
– Press LIST twice to display
L.OPT and then key in the
appropriate number (0, 4, 5
or 6).
The preprogramming is done with a Bang & Olufsen
remote control, and must be carried out with both the
central and local system switched to stand-by!