4
P L A C E M E N T
To fasten the BeoLink Active receiver to the wall:
1 Using the wall bracket as a template, mark and drill
the holes in the wall.
2 Using the two screws and wall plugs supplied (A), fasten
the wall bracket.
3 When you have mounted the receiver cable (see page 5)
hang the receiver on the wall bracket and then
secure it with the tiny screw (B).
4 Fasten the cable to the wall and run it to the BeoLink
Active box.
In the following we have listed some advice and require-
ments for the placement of the BeoLink Active:
• The units in the system must
all be placed in a dry place, i.e.
not outdoors (the BeoLink
cable, however, may very well
be run outdoors). Once
connected, the BeoLink Active
box should be fastened to
the wall – e.g. concealed
behind a curtain or a piece of
furniture.
• Place the BeoLink Active
receiver so it can receive the
remote control signals.
• If the receiver is placed next to
a door and at a suitable height,
you can easily switch on or off
by close-up operation when
entering or leaving the room.
Likewise, if it is placed near
your telephone, you can
switch off the speakers while
you are on the phone.
• Avoid placing the receiver in
direct sunlight or direct
artificial light, e.g. a spotlight,
or near objects generating
electrical noise, e.g. light
dimmers, as this will reduce the
sensitivity of the receiver.
• The receiver is designed to
function within a
temperature range of 0 – 55°C
(32 – 130°F). If it is exposed to
higher or lower
temperatures, it may block
the whole system.
The box is designed to function
within a temperature range
of 10 – 40°C (50 – 105°F).
• The receiver cable supplied is
5 metres (15'). This is the
maximum lenght of cable to be
used.
If you have installed more units
throughout the house, make
sure that the remote control can
only activate one receiver at a
time.
Summary of Contents for BeoLink Active
Page 1: ...B E O L I N K A C T I V E...
Page 8: ......
