Securing the cables:
For safety reasons, the
mains lead must be fastened to the loud speaker.
To do so, tug the mains lead behind the small
bracket on the connection panel. Then run all
cables behind the clamp, and tighten the two
screws.
Cover for the connection panel:
To remove
the cover, grip it along the left and right edges
– as indicated by the two arrows.
When you have made all the connections and
secured the cables, fasten the cover again by
inserting the four pegs on the rear of the cover
into the corresponding holes on the loud speaker.
Power Link cables:
The cables must be of the
type which are marked with a triangle on the
plug. Do not use any of the old type of Power
Link cables, as this will cause noise, and thus
not give optimum sound quality!
Power Link connections:
These connections
carry both the right and left sound signals.
Therefore, you can:
1
Run a Power Link cable from your
Bang & Olufsen system directly to
each loud speaker.
Or
2
Run a Power Link cable from your
Bang & Olufsen system to the first
loudspeaker, and then run another
Power Link cable to the next loud speaker.
This will often help to minimise cable clutter.
Power Link
Mk 3
LEFT
RIGHT
1
LEFT
RIGHT
2
7
Summary of Contents for BeoLab 9
Page 1: ...BeoLab 9 Guide...
Page 12: ......
