Handling and cleaning
Static electricity
Static electricity may damage the product.
Static-protective field service kit.
A static-protective field service kit must always be used when the product is
disassembled or modules are being handled.
Follow the instructions in this Service Manual and use the ESD-mat for both old
and new modules.
Please note:
When mains voltage on the product is required, remove the connection between
the product and the ESD-mat.
The chassis or modules must always be connected to the static-protective field
service kit or placed in an ESD-proof bag.
Symbol of safety components
When replacing components with this symbol, the same type has to be used, also
the same values for ohm and watt.
The new component is to be mounted in the same way as the replaced one.
Transport and handling
It is recommended to:
-
use the product cover when transporting the product.
-
do not move the product when it is operating.
Cleaning
Please refer to the chapter “Final check after repair” or the User’s guides.
STATIC ELECTRICITY
MAY DESTROY THE
PRODUCT
ESD
How to service 1.3
Summary of Contents for BeoLab 9 6217
