Bang & Olufsen BeoLab 7-6, User Manual

Page: 4 / 12

Set up the loudspeaker
We recommend that you follow
this procedure:
– Disconnect your Bang & Olufsen
system from the mains supply.
– Fasten the loudspeaker as
explained on the next page.
– Connect the loudspeaker and set
the position switch as explained
in ‘Cable connections’ (pp. 6–7).
– Connect the entire system to the
mains again.
Cautions!
– Make sure that the loudspeaker
is placed and connected in
accordance with the instructions
in this Guide. To prevent injury,
use Bang & Olufsen approved
stands and wall brackets only!
– The loudspeaker can only be
switched off completely by
disconnecting it from the wall
socket.
– Do not attempt to open the loud-
speaker. Leave such operations
to qualified service personnel!
– The loudspeaker is designed for
indoor use in dry, domestic
environments only, and for use
within a temperature range of
10–40º C (50–105º F).
– Always place the loudspeaker in
a horizontal position, and do not
place any items on it.
– In order not to block the sound
emitting from the rear bass
reflex ports and the bass units
on the bottom, leave a minimum
of 6 cm (2½”) free space behind
and below the loud speaker.
– Prolonged listening at high
volume levels may cause hearing
damage!
Handling the loudspeaker:
In
order not to dent or scratch the
loud speaker front grill, we
recommend that you lift the loud­
speaker by holding on to the two
bass units on the bottom. Do not
support the loud speaker holding
the loud speaker front grill!
4