Remove the left slave unit, to gain access to the potentiometers.
When the Main chassis is replaced, the potentiometers on the new chassis are set
to the same value (click) as the old chassis. No further adjustment is used, as long
as the driver units not have been replaced.
When a driver unit is replaced, either treble or bass, you will need to perform an
adjustment on the two potentiometers. On the new service driver unit there will
be a dB value stated on the back. This value is used along with the table below to
adjust the correct potentiometer.
Bass adjustment (the lower potentiometer)
Stated value on the
service driver unit
Position of the click-
potentiometer
3,5 - 3,8
0
2,6 - 3,4
1
1,8 - 2,5
2
1,1 - 1,7
3
0,4 - 1,0
4
-0,3 - 0,3
5 (0 dB level)
-0,4 - -0,9
6
-1,0 - -1,7
7
-1,8 - -2,4
8
-2,5 - -2,8
9
Treble adjustment (the upper potentiometer)
Stated value on the
service driver unit
Position of the click-
potentiometer
3,1 - 3,7
0
2,4 - 3,0
1
1,7 - 2,3
2
1,0 - 1,6
3
0,4 - 0,9
4
-0,3 - 0,3
5 (0 dB level)
-0,4 - -0,8
6
-0,9 - -1,5
7
-1,6 - -2,2
8
-2,3 - -2,7
9
5.2 Service hints and adjustment, English
Summary of Contents for BeoLab 3 6881
