Bang & Olufsen BeoLab 1, User Manual

Page: 7 / 12

7
…to a non-Bang & Olufsen
product
The phono socket marked LINE must be
used instead of the Power Link sockets if
the BeoLab 1 is to be connected to a non-
Bang & Olufsen product (using e.g. a cable,
part no. 6270595). The signal must be on a
regulated low-voltage level.
• Connect one speaker to each of the sound
channels.
• The switch marked L • R • LINE must, in this
case, be set to LINE on both speakers (set the
switch to its utmost right position).
…to the mains
Connect the enclosed mains cord to the
socket marked POWER, but do not connect
it to the wall socket yet.
Running the cables
You might find it easier to “thread” the
cables into the enclosed cable cover before
you connect them to the BeoLab 1.
Cable cover: Use the enclosed tool to “zip up”
the cable cover when you have placed both the
mains cord and the Power Link cable inside it.
1 POWER LINK 2
POWER
L R LINE
SPEAKER POSITION
FREESTANDING
AGAINST WALL
IN CORNER
25 cm / 10"
L • R • LINE
switch
Power Link
connections
Connection to
the mains
LINE
connection
Speaker Position
switch
Cable clamps: For safety reasons you must
fasten the cables and cable cover with the two
clamps, as shown.