5
Registration of a handset to the
base
The handset must be registered to the base. Up
to 8 handsets can be registered to one base.
To register the first handset…
> Connect the base to a power outlet, as described
in the BeoLine Guide. The indicator light flashes
red, and the base is open for five minutes.
> If you have connected the base, but the
indicator light is not flashing red, disconnect
the base, wait two seconds, and reconnect it.
> Press to switch on the handset. The display
prompts you to register the handset.
> Press
OK
. The handset searches for an open base.
> When a base is located, the PARK number –
which identifies the base – is shown. Check the
number in the display against the number
under the cover on the bottom of the base.
> If the numbers do not match, push the
Track
point
down to view the available bases.
> When the desired base is shown, press
OK
to
register the handset. The display prompts you
to wait until registration is complete.
> If the base prompts you for a pincode, enter the
pincode and press
OK
.
> When registration is complete,
Enter handset
name?
appears in the display. You can then
name the handset as described on page 6. If
you wish to name the handset later*, press
C
.
To register additional handsets…
> With a registered handset, bring up the
Base
menu*.
> Push the
Track point
down until
Open base
is
shown in the display and press
OK
.
> Press on the handset to be registered to
switch it on. The display prompts you to register
the handset.
> Follow the procedure described above.
*This is done via the ‘Advanced settings’ menu,
described on page 34 in the Guide.
Register
handset
to base?
OK
OK
...
Searching base
Wait...
...
Registering...
Wait
Enter handset
name?
Base 1/2: 36-
000223344556
Base 2/2: 36-
000223344557
Indicator
light
Summary of Contents for BEOCOM 2
Page 1: ...Get started BeoCom 2 ...
Page 19: ...19 ...
Page 23: ......
Page 24: ...www bang olufsen com ...