Insulation test
Each set must be insulation tested after having been dismantled.
Make the test when the set has been reassembled and is ready to be returned to
the customer.
Flashovers must not occur during the testing procedure!
Make the insulation test as follows:
Short-circuit the two pins of the mains plug and connect them to one of the
terminals of the insulation tester. Connect the other terminal of the insulation
tester to the chassis pin of the arial socket.
NOTE!
To avoid damaging the set it is essential that both terminals of the insulation tester
have good contact.
Slowly turn the voltage control of the insulation tester until a voltage of 2.5kV and
max. 5mA is obtained. Maintain that voltage for one second, then slowly turn it
down again.
Insulation test, English 7.1
Summary of Contents for BeoCenter 2
