Bang & Olufsen BeoCenter 2, User Manual

Page: 34 / 44

6
Use the diagram and graphics
imprinted on the Socket unit when
locating the sockets.
Do not connect your system to the
mains until you have finished
connecting all other cables.
To access the sockets in the Socket
unit, you must remove the cover –
refer to page 5 and the graphics
imprinted on the cover.
Connect the cables
AUX
IN
R R
L L
AUX
OUT
LINE
OUT
R
L DIG.OUT
VIDEO
S-VIDEO
CTRL
AM FM
~
POWER LINK MASTER LINK
MASTER UNIT
AV
Master unit connection
Connect the Master unit to the Socket unit with
the enclosed cable.
Aerial connections – AM/FM
Connect your FM aerial to the socket marked FM
and your AM aerial, if any, to the socket marked
AM.
When using an AM loop aerial, tune in to the
radio station you want, then turn the aerial
horisontally until you receive the best possible
signal.
Loudspeaker connections – Power Link
Connect your active speakers to the socket
marked Power Link and loop the signal through
from speaker to speaker. Refer to the Guides for
the BeoLab Loudspeakers.
Remember to set L • R • LINE switch on the
BeoLab speakers to L and R (left and right),
respectively.
When headphones are plugged in, the speakers,
connected to your music system, are muted.
Prolonged listening at a high volume level may
cause hearing damages.
Master Link connections
Use a Master Link cable to connect the sockets
marked Master Link on the Socket unit and the
television.
The socket is also used for BeoLink distribution of
sound throughout the house.
Audio/Video connections – AV
Use a 21-pin AV cable to connect the sockets
marked AV on the Socket unit and the television.
For connection without a 21-pin AV cable, refer to
the next page.
DIG.OUT
If you connect your music system to a Bang &
Olufsen television with a built-in surround sound
module, you must connect the socket marked
DIG.OUT to the INPUT 1 socket on your television.
If the required cable is not enclosed, it is available
from your Bang & Olufsen retailer.
Mains connection –
~
Plug the mains cord into the socket marked
~
on
the socket unit, but do not connect it to the mains
before you have finished all connections.
Master Link
connection to
other rooms…