B&R MAPPC800-ENG, User Manual

Page: 58 / 396

58
Technical data • Entire device
Panel PC 800 User's Manual V 1.00
2.6.9 Status LEDs
The status LEDs are on the back of the system unit.
Status LEDs
LED Color Meaning
Power
Green On Supply voltage OK
Red On
The system is in standby mode
(S5: soft-off mode or S4:
Hibernate mode -Suspend-to-
Disk)
Orange
1)
1) Only lit when add-on UPS module is installed.
On
Supply voltage not OK; the
system is operating on battery
power.
red /
green
Blinking
MTCX upgrade service
function: A red/green blinking
power LED indicates a faulty
or incomplete MTCX upgrade.
The MTCX runs using the
firmware version installed
when delivered. This could be
caused by a power failure
during an MTCX upgrade. An
MTCX upgrade must be
performed again.
HDD Yellow On
Signals IDE drive access (CF,
HDD, CD, etc.)
Link Yellow
On
Indicates an active SDL
connection on the monitor /
panel plug.
Blinking
An active SDL connection has
been interrupted by a loss of
power in the display unit.
Run Green
On Application running
Off Application is not running
Table 33: Data - status LEDs