260
Software • Automation Device Interface (ADI) - Control Center
Panel PC 800 User's Manual V 1.00
8.3 SDL equalizer setting
1) Start the
Control Center
in the
Control Panel
.
2) Then select the
Display
tab.
3) Click on
Settings
. This opens the following dialog box:
You can change the display's SDL equalizer settings in this dialog box. The equalizer is
integrated in the Automation Panel and adapts the DVI signal to various cable lengths. The
equalizer value is automatically calculated based on the cable length: You may set a different
equalizer value in order to obtain the best possible display quality (e.g. with low-quality cables or
poor DVI signal quality).
The value is optimally defined for the cable length when using the "Automatic setting".
The equalizer value can only be changed if the function is supported by Automation Panel 900
(starting with Panel Firmware version 1.04 or higher).
Figure 129: ADI Control Center - SDL equalizer settings
Summary of Contents for MAPPC800-ENG
