Software • BIOS options
Section 4
Soft
w
are
281
Automation PC 620 with 945GME N270 CPU board User's Manual V 1.10
1.4.5 Chipset configuration
Figure 126: X945 Advanced Chipset Configuration
BIOS setting
Meaning
Setting options
Effect
DRAM Frequency
Option for setting the RAM frequency.
Auto
Frequency set automatically by the BIOS.
400, 533 MHz
Desired clock frequency set manually.
Memory Hole
Option for ISA cards with frame buffer. Not
relevant for an APC620.
Disabled
Disables this function.
15MB-16MB
This address area is reserved.
DIMM Thermal
Control
Option for setting the maximum surface
temperature of the DIMM module. The
module is cooled by limiting the memory
bandwidth if the defined surface
temperature is reached.
Disabled
Surface temperature not limited.
40°C, 50°C, 60°C, 70°C,
80°C, 85°C, 90°C
Temperature limit value for the limitation.
DT in SPD
Option to determine whether the GMCH
(Graphics and Memory Controller Hub)
supports DT (Delta Temperature) in the
SPD (Serial Presence Detect)
Management Algorithm of the DIMM
module.
Disabled
Disables this function.
Enabled
Enables this function.
TS on DIMM
Option to determine whether the GMCH
(Graphics and Memory Controller Hub)
supports TS (Thermal Sensor) in the
Thermal Management Algorithm of the
DIMM module.
Disabled
Disables this function.
Enabled
Enables this function.
Table 176: X945 Advanced Chipset setting options
Advanced
Advanced Chipset Settings
Options
DRAM Fre
q
uency
[Auto]
Auto
400 MHz
Memory Hole
[Disabled]
DIMM Thermal Control
[Disabled]
533 MHz
DT in SPD
[Disabled]
TS on DIMM
[Disabled]
High Precision Event Timer
[Disabled]
IOAPIC
[Enabled]
APIC ACPI SCI IRQ
[Disabled]
C4 On C3
[Disabled]
Select Screen
Select Item
+-
Change Option
F1
General Help
F10
Save and Exit
ESC
Exit
BIOS SETUP UTILIT
Y
v02.66 (C)Copyright 1985-2009, American Megatrends, Inc.
Summary of Contents for Automation PC 620
Page 2: ...2 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 4: ...4 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 6: ...6 Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...
Page 568: ...568 Appendix A Glossary Automation PC 620 with 945GME N270 CPU board User s Manual V 1 10 ...