Technical data • Individual components
78
Panel PC 2100 swing arm user's manual V1.00
Product ID
5ACCIF01.FPSC-000
Relative humidity
Operation
5 to 90%
Storage
5 to 95%
Transport
5 to 95%
Mechanical characteristics
Weight
25 g
Table 68: 5ACCIF01.FPSC-000 - Technical data
1)
More information is available in the Automation Studio help system (Communication - POWERLINK - General information - Hardware - IF / LS).
3.4.2.3.1 POWERLINK interface - Pinout
The POWERLINK interface on the system unit is referred to as IF1.
POWERLINK - IF1
1)2)
Cabling
S/STP (Cat 5e)
Cable length
Max. 100 m (min. Cat5e)
Status LED
On
Off
Green
See Status/Error LED.
Link LED
On
Off
Yellow
Link (POWERLINK net-
work connection available)
Activity (blinking - da-
ta transfer in progress)
RJ45, female
1
Status LED
Link LED
Table 69: 5ACCIF01.FPSC-000 - POWERLINK interface
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
This interface is referred to as IF1 in Automation Studio / Automation Runtime.
3.4.2.3.2 COM serial interface - Pinout
The COM serial interface on the system unit is referred to as IFx.
Serial interface COM - IFx
1)2)
RS232
Type
RS232, modem-capable, not electrically isolated
UART
16550-compatible, 16-byte FIFO
Transfer rate
Max. 115 kbit/s
Bus length
Max. 15 m
Pin
Assignment
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
GND
9
RXD
10
TXD
10-pin, male
1 3 5 7
2 4 6 8 10
9
Table 70: 5ACCIF01.FPSC-000 - COM interface
1)
The interfaces, etc. available on the device or module have been numbered as such for easy identification. This numbering may differ from that used by
the particular operating system.
2)
This interface can only be used in Automation Runtime and is referred to as IF5 in Automation Studio / Automation Runtime. It is not a "PC interface" and
therefore not shown in BIOS on APC2100 / PPC2100 systems.
