lay on
Fit each soft closer next
to centre muntin on the
top or bottom panel.
CSS1110 01/12
Fit each Door Stop ‘A’ to the
back of the Frame joined to
the top panel with 2 x screws
supplied
Fit to holes drilled in bottom panel, so that closers are
either side of centre muntin.
Handles
Position as required.
nOTe:
care should be taken when drilling for the handle so as not to drill in to the shelf.
Soft Closer
(This section details all options available.)
Insert Door Hinge into
rear recess in door
Affix Hinge Plate
on cabinet
Now, Clip Hinge onto Hinge Plate
Turn screws as shown to adjust door position
Door Hinges
mounting plate for
inset doors Only
you should follow the details that refer to the system you have purchased.
8
9
10
Frame
Firstly, when fitting soft closers to
framed doors only
,
locate the 4 pre-marked holes in the bottom panel, and
using a 5mm drill bit, carefully drill these to a depth of
12mm.
Fixing of Magnetic Catch
First, carefully push the magnetic
catch , into the holder ,
as shown, until it clips onto the
adjustment screw at the end.
BASE PANEL
8mm
15mm
screw
fixing
adjustment
screw
Fixing of Strike Plate
Using a 3mm drill bit, carefully drill a 3mm hole in the
door, as shown.
Now tap the strike plate into this hole, and close
the door.
lH hung wall door shown
3mm hole drilled
for metal striking
plate
20mm
43mm
The door should be
pushed onto the
magnetic catch,
to close it. Then,
to open the door,
simply push the
door again, and
release, and the
door should open.
If the door does
not open smoothly,
then it may require
further adjustment
of the hinges.
Push-to-open only:
Ar
As
AT
As
Ar
AT
43mm
11mm
This is now ready to be fitted to the unit.
Carefully mark holes for fixing the holder, in the
positions shown, and using a 3mm drill bit, drill
approximately 5mm
deep.
Then fix the
complete magnetic
holder to the side
panel, as shown.
Once fitted, use the
adjustment screw
to fix the catch
in the optimum
position.
As
