• When not in use, store the gun so that the plunger rod will
not be damaged or bent.
Note:
Always start with a fresh bait tube each day. Over
time, when exposed to air, some baits tend to solidify and
make the gun difficult to operate.
Damaged Plunger Rod
• To replace the rod,
do not
take the gun apart.
• Unscrew and remove the end of the plunger rod, then lightly
press the release knob and pull the rod out of the back of
the gun
• Insert new rod carefully through back of the gun, then at-
tach the tip of the rod.
Suggested Uses
Trouble Shooting
Operating Instructions
Operation
MULTI-DOSE BAIT GUN
USER’S MANUAL
Problem:
Syringe does not hold securely to gun
Solution:
• Check for o-ring, replace if missing.
Problem:
No bait delivered with trigger pull
Solution:
• Check the tip of the syringe for dry bait plug;
check the position of the plunger rod against the
back of the syringe.
Problem:
Bait continues to drip after trigger pull
Solution:
• Select a lower setting.
• Always wear personal protection equipment required
by the insecticide label.
• Keep cap on bait tubes not in use and while
transporting the bait gun.
• Always follow label directions on gel bait
insecticides for use and disposal of empty syringes.
• The Plunger Rod does not
need oil or any lubrication.
• The addition of oil to the
Plunger Rod will result in
dirt sticking to it and block-
ing movement.
• For the application of paste or gel formulations of
insecticides.
• Setting 1-4 are calibrated for syringes with paste
or gel formulations.
Before Starting
• Be sure the plunger rod moves smoothly and is not bent.
• Push the rod release lever forward to move the plunger to
the base of the gun.
Settings #4 – This setting will
deliver the 0.50 gram place-
ment recommended by the
label on Advance, Advion,
Alpine, and Vendetta. Two
(1 gram) or three (1.5 grams)
trigger pulls will deliver the
large placements for Maxforce.
Care and Maintenance
Plunger Rod Maintenance
Attach Syringe
• Retract the plunger to the base of the gun.
• Place the syringe between the locking tabs and twist to the
right.
Select Setting
• Select the setting (1-4) by pulling the
adjustment knob out and turning to the
right or left.
• Align number with the triangle point on
the side of the gun.
Safety Precautions
24020200 Rev 7/12
Setting #1 – This setting will deliver
the 1/4 inch or the 0.25 gram place-
ment recommended by all the major
gel-bait products, including Advance,
Advion, Alpine, Invicta, Maxforce, and
Vendetta.
Setting #2, 3 - This setting typically delivers 0.35 grams of
bait, depending on the product.
For Multi-Dose Guns purchased after August 2012
