• When not in use, store the gun so that the plunger rod will
not be damaged or bent.
• Oil the plunger rod at the back of the gun on a regular basis.
Damaged Plunger Rod
• To replace the rod, do not take the gun apart.
• Unscrew and remove the end of the plunger rod, then lightly
press the release knob (on the top of the gun) and pull the
rod out of the back of the gun
• Insert new rod (twist slightly) carefully through back of the
gun, then attach the tip of the rod.
Suggested Uses
Trouble Shooting
Operating Instructions
Operation
MULTI-DOSE BAIT GUN
USER’S MANUAL
Problem:
Syringe does not hold securely to gun
Solution:
• Check for o-ring, replace if lost or damaged
Problem:
No bait is delivered with trigger pull
Solution:
• Lightly oil the plunger rod
• Check the setting it should not be a 0
• Check the syringe, the bait may be dry
Problem:
Bait continues to drip after trigger pull
Solution:
• Bait formation may be too “wet,” select a lower
setting on adjustment knob
• Always wear personal protection equipment
required by the insecticide label.
• Keep stopper and caps on all bait tubes while
not in use and while transporting the bait gun.
• Always follow label directions on gel bait
insecticides for use and disposal of empty syringes.
In dry conditions, such as the
hot or heated cab of a vehicle,
the oil used to lubricate the
gun may become dry.
The absence of oil on the
plunger rod can result in it
sticking and preventing the
gun from delivering bait.
• For the application of paste or gel formulations of
insecticides
• Setting 1-7 on the bait gun are calibrated for syringes
filled with paste or gel formulations.
Before Starting
• Be sure the plunger rod moves back and forth smoothly; if
not, place a small amount of oil on the rod.
• Push the rod release lever forward to move the plunger to
the base of the gun.
Care and Maintenance
Plunger Rod Maintenance
Attach Syringe
• Retract the plunger to the base of the gun
• Push the syringe against the large gasket between the lock-
ing tabs, and twist to the right.
Select Setting
• Select the setting (1-6) by pulling the
adjustment knob out and turning to the
right or left.
• Align the number with the triangle point
on the side of the gun.
Safety Precautions
24020200 Rev 6/10
Setting #4 = 1/4 gram
Setting #6 = 1/2 gram
Ff
For Multi-dose Guns Purchased prior to August 2012
For Multi-dose Guns Purchased prior to August 2012
