background image

3

Safety instructions – to be strictly observed  

General

•  The ocillation may be used intended and according to this operating instructions only 

together with SONOREX TECHNIK RM - unit. From there additionally all safety instructions of the 
operating instructions of the used unit are valid. 

•  Keep units away from children and also away from persons not instructed for correct use by means of 

these instructions.

•  Protect the unit against corrosive infl uences. 

•  Place the unit horizontally on a dry and solid base. 

•  Keep the unit’s surface and control elements clean and dry!

• 

Use only connecting material supplied with the equipment

.

•  The operating instructions with safety instructions have to remain always with the unit and are to be 

strictly followed!

•  With delivery of the equipment the operating instructions with the safety instructions are to be handed 

over.

Damages and defects

•  After the packing has been removed, check the housing and the operating elements of the unit for any 

damage which might have occurred during transport. If damage due to transport has been discovered, 

do not

 connect the unit to the mains supply, but report the damage immediately and in writing to the 

carrier and to your supplier. 

Save

 the original packing.

•  In case of defects disconnect the mains supply immediately.

•  The unit must only be repaired by authorised personnel or the manufacturer.

• 

Use only

 original parts or of the same quality for replacement!

•  Exchange defective mains cable completely.

Operation

•  Connect the unit to a grounded safety socket only.

•  Pay attention to environmental conditions (chapter 8). 

•  Do not allow the unit to run without supervision.

•  Do not touch moving parts when the unit is in operation! 

•  There is danger of squeezing between edge of tank and bracket during operation of the oscillation 

(MO).

•  Put on or take off cleaning goods and the basket from the bracket only when the unit is switched off. 

Summary of Contents for SONOREX TECHNIK MO16.2









Reviews: