27
Smart Pro
installation instructions
a. Switch power on and the BLUE LED on the CLOSE button
will start to flash to indicate that the opener is ready
to set the Close travel limit
b. Press the MODE button until the TRANSMIT
LED is lit.
c. Press and HOLD the CLOSE button
to set the Open
/ Stop / Close function. The Main light will start to flash
rapidly.
d. Press and hold button 1 on the transmitter, then release
transmitter button.
e. Press and hold button 1 on the remote control button
again until the main light stops flashing rapidly.
f. Release both buttons. The transmitter button is now
coded, press to test and observe the speed of the door
through a full cycle.
g. The drive speed is set to the fastest setting by default.
This may not be suitable for larger doors or for single
piece doors:
CLOSE limit:
i. Using the programmed transmitter, press and hold
the button 4 to close. To inch the door, single presses
of the button 4 will move the door to desired CLOSE
limit. We recommend the CLOSE limit position being
the first point of contact of the rubber strip ( at the
bottom of the door) with the ground.
ii. If the door overshoots, press the OPEN button 1 on
the remote to move the door in the OPEN direction.
iii. When the door is at the desired CLOSE position, press
the SET button 2, the GREEN LED on the OPEN button
will now flash.
Button 1
(inch Open)
Button 2
(Set)
Button 4
(inch Close)
OPEN limit:
i. Using the programmed transmitter, press and
hold the button 1 to open. To inch the door, single
presses of the button 1 will move the door to
desired OPEN limit. We recommend the OPEN limit
position being the height of the garage opening
ii. If the door overshoots, press the CLOSE button
4 on the remote to move the door in the CLOSE
direction.
WARNING! The door will automatically close,
open and close again after the next step.
Ensure that nothing is in the door’s path.
iii. When the door is at the desired OPEN position,
press the SET button 2. The door will now
automatically close and open to calculate the
safety obstruction settings.
G - Setting Limits via Transmitter
The SPEED setting on the opener can not be
adjusted when setting limits via the transmitter.
Follow section 12.1 to set limits and adjust speed.
tip
