22
Carriage Bolt 8mm x 65mm
Nut 8mm
Lock W asher 8mm
Sheet Metal Screw
HARDWARE SHOWN ACTUAL SIZE
Header Wall
Vertical
Centreline of
Garage Door
Finished Ceiling
Optional
Placement
of Door
Bracket
Header
Bracket
Door
Bracket
25mm Support
For a door with no exposed framing,
or for the optional installation, use
lag screws 8mm x 40mm (Not Provided)
to fasten door bracket.
METAL DOOR
Top of Door
(Inside
Garage)
Door
Bracket
Optional
Placement
Top Edge
of Door
Self-Threading
Screw
8mm x 13mm
Door
Bracket
Top of Door
(Inside
Garage)
Carriage Bolt
8mm x 65mm
(Not Provided)
Optional
Placement
Lock
Washer
8mm
Nut
8mm
Top Edge
of Door
WOOD DOOR
HORIZONTAL AND VERTICAL
REINFORCEMENT IS NEEDED
FOR
LIGHTWEIGHT GARAGE DOORS
(FIBREGLASS, ALUMINUM, STEEL,
DOORS WITH GLASS PANEL, ETC.).
(NOT PROVIDED)
ONE-PIECE DOORS
Please read and comply with the warnings and
reinforcement instructions on the previous page.
They apply to one-piece doors also.
• Centre the door bracket on the top of the door, in
line with the header bracket as shown. Mark either
the left and right, or the top and bottom holes.
•
Metal Doors:
Drill 4.5mm (3/16") pilot holes and
fasten the bracket with the 8 x 13mm (1/4"-
14x5/8") self-threading screws provided.
•
Wood Doors:
Drill 8mm (5/16") holes and use
8mm x 2" (5/16"x2") carriage bolts, lock washers
and nuts or 8 x 40mm (5/16"x1-1/2") lag screws
depending on your installation needs.
NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement drawing.)
